Then install them on your Laptop. Before we proceed with the software section and coding, let's prepare our board for this project. As mentioned earlier in this article, we are going to control an LED using a push button.
Now, if you have seen the video linked above, you should already know that your STM32 Development Board has two sets of connector pins on either side called ST Morpho pins. We have connected a push-button and an LED to these pins as shown in the circuit diagram below. Once the connections were made, my test set-up looked like this. Alternatively, we can also use the inbuilt LED and push button on the board.
These inbuilt LEDs and push-button also connected at the same pin as shown in the circuit diagram. We have added external components only for practice. The below pin diagram of the STM32 Development Board will come in handy to know where each morpho pins are connected to onboard.
If you have a different board search for its respective name. Step 3: Now click on yes as shown in the picture below, to initialize all the peripherals in their default mode. We can later change the required ones as needed by our project.
Step 4: Now users can select the desired setting from the categories. Here in this tutorial, we are going to toggle an LED using a push button. Read more Read less. Something went wrong with the server request. Please try again in a few moments. Project Title:. A project title is required. Project Description:.
A project description is required. An application is required. End Application:. Please choose a sub-application An end application is required. Nature of Business:. Military Related:. Yes No A military relation status is required. Please keep me informed about future updates for this product.
Confirm Request Cancel. Request for software successfully submitted. The approval process may take up to 48 hours. After you have been approved, you should receive a link to the requested software via email. Start Over. Get Software Your browser does not support JavaScript. Some components may not be visible. You might also like Featured Videos. Well, it depends. However, if you want the full power of Intellisense at your fingertips and faster build times this is the way to go.
Trust me, it makes a whole lot of difference in development. Open Environment variables setup dialog. Depending on your system configuration and administrative rights you may choose to modify either the User variables or the System variables. Make the following changes:. Press F1 and type user settings json. In the opened file, add the following property and save. We will create a folder to serve as a workspace for our projects. We will configure two projects to get the development going.
Click on Add folder to the workspace. Press F1 and type save workspace. Select Workspaces: Save Workspace As. Press F1 and type save project. Press F1 to edit projects. Duplicate the JSON project entry to create another project named blink pointing to our blink subfolder.
Your template project is now open. You will need to update this file when you create new projects to let Project Manager extension know where your stuff is. Adjust the defines section to match the microcontroller used and your HSE frequency.
Press F1 and type config task. Select Tasks: Configure tasks.
0コメント